Magneto puller
Two part puller used to pull magneto on all Rotax points ignition systems.
|
876 065 Puller (20) |
|
876 080 Puller ring (18) |
940 580 Bolts (19) 3 required |
|
876 950 Dial
indicator
Used to aid in timing all Rotax engines equipped with points and condenser ignitions
systems. Can also be used for any continuity tests.
|
|
|
Alignment bar(s)
Used to align cylinders prior to torquing heads on
532/582 Rotax ultralight engines.
Cylinder alignment tool 876 570
( You can also place the cylinder head on upside down to align
cylinders.)
|
|
|
Wrist pin clip insertion tool
Used to install wrist pin clips in piston on all
Rotax ultralight engines. Part # 877 015
This tool is a must - while it can be done with an
ice pick style probe the tool pays for itself in less "aggravation."
|
Piston fixation
- 1 required tool
a specially designed tool for holding pistons in place , when reinstalling cylinders.
(A pair of pliers with rubber coated handles will
work.)
|
|
|
Reduction drive gear puller
Used to pull gear on crankshaft on most Rotax ultralight engines equipped with Rotax
A and B reduction drives.
276 808 |
|
Crankshaft locking pin
A specially designed pin for locking up the
crankshaft on Rotax ultralight engines. The use of any other pin for
this purpose can cause severe engine damage.
Part #876 640 Crankshaft fixation pin.
This pin is comes with the Rotax engine tool kit.
|
|
|
Piston pin puller
Used to remove wrist pins from piston, and install and remove
cageless bearings. 877-091
|
|
Circlip removal tool
Used to remove circlips from pistons, during disassembly of Rotax ultralight engines.
( A bent ice pick style of tool.)
|
Mechanics tools
|
|
Allen wrenches
4 mm required to remove stator unit
5 mm required to remove fan tower
6 mm required to remove exhaust manifold and crank bolts
|
Feeler gauges
Used to set point, and spark plug gap on Rotax ultralight engines. Used to measure ring
end gap.
Used to measure cylinder/piston wear.
Used to measure point gap. (Brass gauges are preferred) |
|
|
Spark plug wrench used to remove spark plugs. Used to remove fan pulley nut. Supplied with Rotax tool kit.
|
Sockets
10 mm used to remove recoil, lower shroud and crankcase bolts
13 mm used to remove top shroud bolts, intake manifold, cylinder head, and crankcase
bolts.
24 mm used on magneto puller
1 3/16 "/30mm 6 point, used to remove magneto nut.
Ratchet
Used in conjunction with sockets in disassembly of the Rotax ultralight engine.
|
Screw drivers
blade/Phillips
Used to remove top of carburetor. Used to remove intake flange, adjust carburetor, adjust
points, tighten carburetor clamps.
Wire brush
Used in the cleaning of engine parts after disassembly.
Torque wrenches
1. inch lbs - 0 - 300
2. ft lbs -0 - 100
Used in torquing all the nuts and bolts during reassembly.
Cylinder hone
Used to remove glaze on cylinders, and install proper cross hatching pattern.
Hone Oil
|
Telescoping gauges
Used to measure cylinder wall clearances.
|